Setting A Password; Turning On The Password And User's Logo - Epson PowerLite 821p User Manual

Setting a Password

1. Press the button on the remote control for about 5 seconds
Freeze
until you see the Password Protect menu:
2. Select and press
Password
the password?
3. Select and press
Yes
4. Hold down the
Num
numeric keypad to enter a 4-digit password.
The password will be displayed as
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.

Turning On the Password and User's Logo

1. To enable the password, press the
control for about 5 seconds until you see the Password Protect
menu
2. Select
Power ON Protect
3. Select and press
ON
. You see the message
Enter
.
Enter
key on the remote control and use the
. After you enter the last
****
button on the remote
Freeze
and press .
Enter
. Then press
Enter Esc
Change
button to
Esc
.
Fine-tuning the Projector
note
If a password has already
been set, you see the
Password Protect Release
screen. See "Starting the
Projector with a Password"
on page 66.
Hold down this button to
activate the numeric
keypad
Use these buttons like a
numeric keypad to enter
the password
65