Epson PowerLite 821p User Manual page 31

3. Connect the other end to an electrical outlet.
The light on top of the projector turns orange, indicating
Power
that the projector is receiving power but not yet turned on. Wait
until the light stops flashing but stays orange.
4. Turn on your computer or video source if you have not already.
5. Press the P
Power
(You can also press the P
Projector
The projector beeps and the
projector warms up. The projector lamp comes on in a few
seconds. When the
to start.
6. If you don't see your image, press the
the projector or remote control repeatedly until you see it.
(Windows only: If you see a message saying that Windows has
found a plug-and-play monitor, click
7. If you are prompted to enter a password, see page 66.
To focus and adjust the image, see page 35. If a projected image fails
to appear even after you press the
To Do If You See a Blank Screen" on page 33.
button on top of the projector to turn it on.
button on the remote control.)
Power
Power button
light flashes green as the
Power
light stops flashing, you're ready
Power
Source Search
Cancel
Source Search
Remote control
button on
.)
button, see "What
note
If you are using the remote
control for the first time, be
sure to insert the batteries as
described on the Quick
Setup sheet.
If the Direct Power ON
feature has been enabled (as
described on page 60), you
don't need to press the
button to turn the
Power
P
projector on. Just plug the
projector into an electrical
outlet. When the
Power
light stops flashing and stays
green, the projector is ready to
use.
warning
Never look into the lens when
the lamp is on. This can
damage your eyes, and is
especially dangerous for
children.
Projecting
31