Epson PowerLite 821p User Manual page 60

note
When
Direct Power
is turned on, turn the
projector off as you would
normally. See page 41 for
instructions.
When Power is
Direct
enabled, it's a good idea to
unplug the projector after
turning it off. Otherwise the
projector will turn on
automatically when power is
restored after a power failure.
Fine-tuning the Projector
60
Projection
Projector is in front of the screen.
Front:
Front/Ceiling:
upside-down from the ceiling.
Projector is behind the screen.
Rear:
Rear/Ceiling:
upside-down from the ceiling.
Operation
Direct Power:
as soon as you plug in the power cord. You don't have to
press the P
Power
Sleep Mode:
lamp automatically turns off when the projector has not
received any input signals for 30 minutes. This conserves
electricity, cools the projector, and extends the life of the
lamp. To resume projecting, press the P
Standby Mode
Set to
Network ON
network and perform other network functions when the
projector is in standby mode.
COM Port
Normally you don't have to change this setting. Both
and
RS-232C
mouse.
RS-232C
control the projector from a computer with the EMP
Link 21L software, which can be downloaded from
www.support.epson.com
the projector off and then on again to enable it.
Language
Select the language to be used for projector menus and
messages.
4. When you're finished, press
Projector is in front of the screen, mounted
Projector is behind the screen, mounted
When this feature is enabled, projection starts
button.
When this feature is enabled, the projector
to monitor your projector over a
let you use the remote control as a wireless
is also used for ASCII control codes and to
. If you change the setting, turn
or
Esc Menu
button.
Power
USB
.