Safety Precautions - Craftsman 320.10871 Operator's Manual

z_WARNING:
BE SURE to read and understand all instructions in this
manual before using this circular saw. Failure to follow all instructions may
result in hazardous radiation exposure, electric shock, fire and/or serious
personal injury.
SAFETY PRECAUTIONS FOR LASERS
This circular saw has a built-in laser light The laser is a Class Ilia and emits output power
of a maximum 1 mW and 635-665nm wavelengths These lasers do not normally present
an optical hazard However, DO NOT stare at the beam as this can cause flash blindness
The following label is on your tool.
It indicates where the saw emits the
laser light. BE AWARE of the laser light
location when using, ALWAYS MAKE
SURE that any bystanders in the vicinity
of use are made aware of the dangers
of looking directly into the laser.
[ /_,WARNING:
LASER LIGHT. LASER RADIATION. Avoid Direct Eye
Exposure. DO NOT stare into beam. Only turn laser beam on when the saw
is on the workpiece. Class Ilia laser,
[ _WARNING:
Use of controls, adjustments or performance of procedures
other than those specified in this manual may result in hazardous radiation
exposure.
[ Z_WARNBNG:
The use of optical instruments such as, but not limited to,
telescopes or transits to view the laser beam will increase eye hazard.
1 DO NOT remove or deface any product labels. Removing product labels
increases the risk of exposure to laser radiation.
2, The laser beam can be harmful to the eyes. ALWAYS avoid direct eye exposure.
DO NOT look directly into the laser beam output aperture during operation DO NOT
project the laser beam directly into the eyes of others. Turn laser on ONLY when
making cuts.
3 Laser enhancing safety glasses are included to enhance the laser beam in bright light
conditions DO NOT wear these glasses if they interfere with the safe operation
of this saw.
4, The laser on the circular saw is not a toy. ALWAYS keep out of the reach of
children, The laser light emitted from this device SHOULD NEVER be directed
towards any person for any reason,
5. BE SURE the laser beam is aimed at a workpiece (such as wood or rough
coated surfaces) that does not have a reflective surface
4