Craftsman 320.10871 Operator's Manual page 25

"T
INSTALLING AND USING
THE EDGE GUIDE cont.
7
8
Place the edge guide firmly
against the edge of the workpiece
(See Fig, 14a) Doing this will
give you a true cut without
pinching the blade
BE SURE that the guiding
edge of tile workpiece is straight so
you can get a straight cuL
ALWAYS LETTHE BLADE
REACH FULL, SPEED, then
carefully guide the saw into tile
workpiece, DO NOT bind the
blade in the cut Push the
saw forward at a speed
where the blade is not laboring
Fig, 14
Fig. 14a
HOWTO SETYOUR BEVEL ANGLE (Fig. 15)
1. Unplug the saw,
/iX WARNING:
ALWAYS unplug saw before making any adjustments. Failure to
unplug the saw could result in aceiden'_al starting which can cause serious personal
injury.
2 Loosen bevel adjustment lever (see Fig 15)_
3 Raise the motor housing end of the saw
until you reach the desired angle setting
on the bevel scale
4 Tighten the adjustment lever securely
Polnter
Fig. 15
Bevel Adjustment Lever