Craftsman 320.10871 Operator's Manual page 28

POSITIVE0° BEVEL STOP
Your s awhasa positive 0 ° bevel s topanditwasadjusted atthefactory toassure
0° angleofthesawblade for900 cuts However, shipping c ancause misalignment
HOWTO CORRECTTHE 0 ° ANGLE SE"t-rlNG (Figs.18, 18a and 18b)
1 Unplug the saw
Z_ WARNING:
ALWAYS unplug saw before making any adjustments. Failure
to unplug the saw could result in accidental starting which can cause serious
personal injury.
Fig. 18 Carpenter'sSquare
Saw Blade
Bevel
}cale
Bevel
Pointer
Bevel Adjustment Locking Lever
2 Place saw in an upside down position on workbench
3. Use a carpenter's square to check the squareness of the saw blade to the base of your saw.
4 If saw is not square, loosen bevel adjustment locking lever (see Fig. 18).
5. Loosen bevel adjust locking nut counterclockwise,
away from bevel adjust bracket, with small wrench
7,
S
(see Fig 18a).
Use Phillips
screwdriver to
turn bevel adjust
screw up or down
to adjust base
until square with
the blade
(see Fig 18b).
When base is square,
tighten nut clockwise
until tight up against
bevel adjust bracket
Tighten bevel
adjustment lever
Fig, 18a
Bevel Adjust Bracket
28