Table of Contents
Advertisement
Setting the Printer Frame Type
Before setting the printer protocol, you must follow the procedure below to
set the printer frame type to enable communication between the computer in
use and the printer. Use the software application below to set the IP address.
•
Important
z The GARO Device Setup Utility must be installed on your computer in order to
use this utility to make the settings. Ask your system administrator to install the
GARO Device Setup Utility on your computer. (Æ Setup Guide)
z Before setting the Frame Type, confirm that the printer is switched on and
connected to the network.
z The MAC address is required to perform the setting with the GARO Device Setup
Utility or the ARP/PING command. If you need to confirm the MAC address, use
the printer operation panel to print a Status Print or Ext. I/F Print.
GARO Device Setup Utility (Æ P.4-4)
1. Press the Online button. The Online lamp switches off.
2. Press the Cancel Job/Utility button.
3. Press
or
to select Status Print or Ext. I/F Print then press
.
Setting the Printer Frame Type
4-3
Advertisement
Table of Contents
