Setting The Line Properties - Altigen AltiWare ACM 5.1 Administration Manual

Chapter 15: Extension Configuration
Assigning a Location to a Physical Extension
When changing a virtual extension to a physical extension, the Location parameters are
available. If you know which board and channel this extension is wired to, you can use
the Prev and Next buttons to select the correct board and channel number for this
physical extension.
Changing the Location
To change the location of a physical extension, select the extension number in the list of
extensions, then click the Prev or Next buttons to change the board and channel
settings until the location you want is displayed. Like other changes, this change isn't
finalized until you click Apply.

Setting the Line Properties

For a physical extension, you can configure hardware options on the port used for the
extensions. To do so, select the extension number in the list of extensions, then click the
Line Properties button to open a dialog box that is specific to the board used for the
extension.
The Line Properties are somewhat different for Quantum Board than for Triton Analog
Station Boards. The subsequent sections deal first with Quantum, then with Triton
Analog Station.
Quantum Line Properties
If you select a Quantum board extension and click Line Properties, you'll see the
Quantum Line Properties dialog box.
Figure 2. Quantum Line Properties dialog box for extensions
AltiWare ACM 5.1 Administration Manual 199