Before Using For The First Time; Using For The First Time; Setting The Time; Selecting The Language - Bosch Nexxt 800 series Operating, Care And Installation Instructions Manual

Before Using For
the First Time
The washing machine must be installed
and connected properly (refer to Page
6).
Before using your washing machine,
read and follow all installation and
operating instructions.
Using For the First
Time
Setting the time
D To define the individual settings
(especially "Program finished at"),
it is necessary to set the time first.
You can set the current time. The
settings are retained even if your
washing machine is not used for up to
6 weeks.
<3 Turn the program selector to any
program.
Example:
<3 Pressthe Menu button until
"Time:" is displayed. The hours
display flashes.
D If no buttons are pushed within 10
seconds the display will revert
back to normal "Ready". Changed
settings will be retained.
i lili
Admit e_ 0ptie_
<3 Pressthe Select button until the
hour display is correct.
<3
iOil i i
Mm
Press the Menu button until the
minutes display flashes.
ii!!_il iiiiiiii_!_ ............ 'iiii iii_iii!iiiiill _I
i iill i ll, fill _i_!i _iiii i °
<3 Pressthe Select button until the
minute display is correct.
The time is now set.
D Press the Menu button, the menu
function ends.
You can select other settings by
pressing the Menu button and change
them by pressing the Select button.
Selecting the language
%
%
<3
The time must be set before the
language can be changed
The program selector must not be
set to Off.
Simultaneously press the Menu
and Select buttons and hold down
(5 seconds) until the current
setting is displayed.
[3
<3
%
Press the Select button until the
desired language is displayed.
Confirm the language selection by
pressing the Menu button.
The language selection can be
confirmed either by pressing the
Menu button or by leaving the
selected language for five
seconds.
Display field
In the first line, the operating and
program progress text is displayed at
the left. The current time is displayed
on the right whenever "Ready" is
displayed on the left.
In the second line, the display indicates
the spin speed and the time at which
the program is expected to be finished,
as well as symbols for Spin speed,
Washing mode, Pre-Soak, Signal and
Child lock.
First washing cycle (with-
out laundry)
Your appliance was tested before
leaving the factory. To ensure a fresh
wash with your initial load of clothes,
run the washer a complete cycle,
without clothes, in advance.
<3 Do not load any laundry.
<3 Turn on the water tap.
<3 Open the flap of the detergent
dispenser.
<3 Pour 1-2 Tbsp. detergent into
detergent chamber I.
%
<3
<3
<3
Do not use special detergents for
delicates or wool (this will cause
excessive sudsing).
Close the flap of the detergent
dispenser.
Close the door.
Set the program selector to
Regular/Cotton hot
The Start/Pause indicator light
flashes (red).
13