Advertisement
FoLLowing is the CommerciaL Mode Operation Setup.
I_+[o_V_._ [,,.-,IN
_ u[_ + I+[,..',]i f..1III I II = I:I hV+l=l+ LIJ
Operating
InstaLLer Menu
To set up the controls for the TV you wiLL need to know how to enter
the L20V54S InstaLLer menu and make changes to the default values
as required. If necessary, familiarize
yourself with the L20V54S
Installer
menu and how to make and save changes in the menu.
[ololo]
II+ [,.IIf;_ ! II:I--.1 [.1:[+]
[ololo]
OptionaL InstaLLer Remote
You wiLL need an InstaLLer remote control similar to the one
shown to the right.
The TV's c[onabLe features need to be set up before 2-5-5 + Menu is done.
This is a critical step.
If the Master TV display paneL's ctonabte features like: Clock Set, adding channel
icons and channel labels, etc. are not done properly, then the cloned L20V54S TVs
wilt at[ have problems. For example, do not do 2-5-5 + Menu more than once or the
TV setup wilt become corrupted. If you need to start the procedure over, then begin
by setting installer
item 117 to 001, and pressing Enter to reset the TV to default
values in the installer
menu. You can do 2-5-4 + Menu mode more than once but
this mode is limited to only editing
channel icons and channel labels.
Refer to the appropriate
section in the Manual for other TV features:
Picture, Sound
etc.
Typical InstaLLer Menu
LT2002 CLone Programmer
As the cloning procedure is being performed, specific steps need to
be done at the indicated times to achieve the desired
result. Be sure to do each cloning task as indicated.
If a procedure or step is left out or not
MPI_
......
performed correctly, then the TV
.++,,_ _ ,°_ .......
setup wilt be wrong and cloning may not
• r,,_
ba_t ry low
....... +''"_:o11]/'.'0_, work. At each step, pay attention
to assure
............
i!_r.!!!'_:;!l_iiiii'i°'i_
the TV screen shows the proper message(s)
when cloning.
If the message indicated
does
not appear, there is a problem with that step
and cloning may not be successfuL. CLoning is
only possible when the signal source is an
Ana[oq channeL, not a digital
channeL.
QuickSet
II Programmer
L T2002
PAG E
4O
Advertisement
