Auto Find Option - Zenith Sentry 2 Z25X22 Operating Manual & Warranty

GET TO:KNOW YOURiREMOTE (MBR3447),
,r
AUTO FIND OPTION (ALTERNATE PROGRAMMING METHOD) _?" _ __:_'_-. _ '_i__ ____
If you've triezl all the codes for your product and none operates iL you can use Auto Find to search Ior the code you need. Follow
the steps below for each product you want to program. Please be patient while using this method; the remote may have to search all
of the codes shown in the chart on the next page.
To Auto Finda Code "
1. Turn On the product you want to operate.
2. Press and hold PRG using a blunt object. Release PRG after
the indicator light turns on.
3. Press the key to be programmed: CATV, VCR, AUX, or TV.
4. Enter "0-0-0," then press ENTER within two seconds. Auto
Find is active when the indicator light flashes and remains lit.
5. Point the remote at the product.
6. Press and release POWER repeatedly, about once a second,
until your product turns Off. The indicator light turns Off when
you press POWER and On when you release it.
7. Press ENTER immediately to save the code. The indicator light
flashes to indicate the code has been saved.
8. Press POWER to turn On your product.
9. Test your product. If the remote fails to operate the functions
you use most often, use Auto Find again to search for a better
code. (Auto Find resumes its search after the last code that was
entered ',andsaved in step 7.)
Notes:
[]
If the indicator light stays on as you press POWER, Auto
Find has tried all of the codes. If the product you want to
control has not turned off, your remote cannot w6tk with
that product.
To cancel Auto Find, press PRG at any time during Auto
Find.
Equipment to be
controlled
Typical Remote
Control
3205-O
7--3