Table of Contents
Advertisement
GET TO KNOW
YOUR
REMOTE
(MBR3447)
AUTO
FIND
OPTION
(ALTERNATE
PROGRAMMING
METHOD)
If you've tried all the codes for your product and none operates it, you can use Auto
Find to search for the code you need. Follow the steps below for each product you
want to program. Please be patient while using this method; the remote .may have to
search all of the codes shown in the chart on the next page.
Typical Remote
Control
Equipment to be
controlled
"_ -
2.,
,r_.
,
.,?=7.-,_?
. 5,......
1. Turn On the product you want to operate.
2. Press and hold PRG using a blunt object. Release PRG after
the indicator light turns on.
3. Press the key to be programmed: CATV, VCR, AUX, or TV.
4
Enter "0-0-0," then press ENTER within two seconds. Auto Find is active when the
indicator light flashes and remains lit.
5. Point the remote at the product.
6. Press and release POWER repeatedly, about once a second, until your product turns Off.
The indicator light turns Offwhen you press POWER and On when you release it.
7. Press ENTER immediately to save the code. The indicator light flashes to indicate the code
has been saved.
8. Press POWER to turn On your product.
9. Test your product. If the remote fails to operate the functions you use most often, use Auto
Find again to search for a better code. (Auto Find resumes its search after the last co&: that
was entered and saved in Step 7.)
Notes:
[]
If the indicator
light stays on as you press POWER,
Auto Find has tried all of the codes.
If the product you want to control has not turned ofi, your remote cannot work with that
product.
[]
To t:ancel Auto Find, press PRG at any time during Auto Find.
3199-O
6--3
Advertisement
Table of Contents
