Auto Find Option - Zenith Sentry 2 SY2518 Operating Manual & Warranty

I
GET TO KNOW THE REMOTE CONTROL: MBR3447
AUTO FIND OPTION
If you have tried all the codes listed in the code table for your brand and type of product, and none of those codes ope,rate your
exluipment, you can use Auto Find to search for the code you need.
Follow these steps for each product you are using:
To auto find a code
1. Turn the product ON.
2. Press and hold PRG until the indicator fights.
,3. Press the mode key on the remote for the product you want to
control: TV, VCR, CABLE, or AUX.
4_. Enter code 0-4) 0, then press ENTER, When the indicator light
flashes three times and remains lit, Auto Find is active.
5. Point the remote toward the product and press and release
POWER, repeating this action until the product turns OFF.
6. Press ENTER immediately to save the code. If your remote fails
to operate tile functions you use most often, you can re-enter
Auto Find and search for a better code.
NOTES:
ISl The indicator light should flash OFF when you press
POWER and back ON when you release it. If the indicator
light stays on when you press POWER, Auto Find has
tried all available codes. If you finish Auto Find and the
product you want to control has not turned off, your remote
cannot control that product.
ISl Pressing PRG at any time during the use of Auto Find wil!
cancel Auto Find, and you will have to start again.
Equipment to be
controlled
Typical Remote
Control
_'_.8-o 3 -- 5