Fcc Compliance Statement; For United States Users - Epson Stylus 800 Series User Manual

FCC Compliance Statement

For United States Users

This equipment has been tested and found to comply with the limits for a Class B digital
pursuant
device, to Part 15 of the FCC Rules. These limits are designed to provide
against
reasonable protection
equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures.
receiver is connected.
The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels which
exceed the limits established by the FCC for this equipment. It is the responsibility of the
use a
user to obtain and
equipment has more than one interface connector, do not leave cables connected to
unused interfaces. Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
For Cunudicrn Users
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
harmful interference in a residential installation. This
WARNING
shielded equipment interface cable with this device. If this