The Print Position Is Not What You Expected; Paper Handling; Single Sheets Do Not Feed Properly - Epson LX-300+ User Manual

The print position is not what you expected

Printing starts too high or too low on the page, or the bottom
part of one page is printed at the top of the next page.
Your software application settings may be incorrect. Check the margin
or top-of-form position setting in your application software.
Page length does not match the length of the paper.
The page length setting in your application may be incorrect. Check
the page length set by your software and adjust it if necessary.
If you are using continuous paper, change the page length in the Printer
Setting mode. See "About Your Printer's Default Settings" on page
2-25.
Regular gaps occur in the printout.
One-inch skip-over-perforation may be set. Set skip-over-perforation
to off in the Printer Setting mode. See "About Your Printer's Default
Settings" on page 2-25.

Paper Handling

Single sheets do not feed properly

Paper does not feed.
Continuous paper may be left in the printer. Remove the continuous
paper. Set the paper-release lever to the single-sheet position. Insert a
new sheet.
Move the paper a little to the left.
4-6
Troubleshooting