Labels - Epson LX 300+II Reference Manual

❏ If you need to adjust the loading position, use your
application software, or change the loading position as
described on page 22.
❏ When you use side-crimped continuous multipart forms, the
copies may not align with the original. If this happens, raise
the paper guide.
For multipart forms, you should not print any closer than
0.5 inch (13 mm) from either side of the paper. For information
on the printable area of envelopes, see the paper specifications
on page 115.

Labels

To print on labels, you must use continuous paper loaded on the
pull tractor. Keep the following tips in mind:
❏ Set the paper thickness lever to the correct position for
labels. (See page 29.)
❏ Choose labels mounted on a continuous backing sheet with
sprocket holes designed for tractor use. Do not print labels
as single sheets, because the shiny backing causes the paper
to slip slightly.
❏ Load labels the same way you load ordinary continuous
paper. See "Printing with the pull tractor" on page 17 for
loading instructions.
❏ Because labels are especially sensitive to temperature and
humidity, use them only under normal operating
conditions.
❏ Do not leave labels loaded in the printer between jobs; they
curl around the platen and may jam when you resume
printing.
Paper Handling
31