Reloading During Printing; Loading Continuous-Feed Paper - Epson LQ-2500 User Manual

whenever required, making single sheets as easy and convenient to use
as continuous-feed paper. The automatic sheet feeder has its own users
manual.

Reloading during printing

When you print a document more than one page long using single
sheets of paper, there are two different ways your application program
can allow you to load a new sheet at the end of a page.
If the program sends characters in a continuous stream, the printer
l
stops printing when it reaches the bottom of the paper and sounds
the beeper. When this happens, the
automatically
If the program handles printing page by page, it probably stops
l
sending characters at the end of a page and prompts you to insert
more paper. In this case the
the first thing you should do is press the
it off.
ON LINE
Once the
printed and load a new sheet in the same way as before.

Loading Continuous-feed Paper

The new push-feed tractor built into the LQ-2500 has several major
advantages over other types. It combines the ability to handle a wide
range of paper widths with an extremely low profile, and it is easy to
load.
The push-feed tractor must be loaded in a slightly different way than
the pin-feed system on Epson FX printers and the usual pull-through
tractors. If you are used to other systems, follow these instructions
carefully
Begin by making sure that the printer is turned off. If you have been
using the printer with single sheets, remove the paper guide. You will
install it in a different way
3-2
ON LINE
ON LINE
light probably remains on, and
light is off, remove the sheet that has just been
Choosing and Loading Paper
light goes off
ON LINE
button once to turn