Epson LQ-2500 User Manual page 35

These current settings can be printed out with the *Print Out Settings
mode, described later in this chapter. A sample printout appears below.
>QUALITY
>FONT
>PITCH
>CONDENSED
>FORM LENGTH
>1" SKIP
>LEFT MARGIN
>RIGHT MARGIN
>CG TABLE
>COUNTRY
>PRINT DIR.
>HALF SPEED
>SHEET FEEDER
>DEFAULT BIN
load
Whenever you
current settings (although the macro remains
then have the option of:
Changing only the current printer settings, or
l
Changing the current settings and saving them
l
Changing
only the current settings is useful when you want different
settings for only one print
a macro.
change
business correspondence in Letter Quality with the Courier font. If you
wanted to write a letter to a friend, you could use that same macro,
change to the more informal Sans Serif font, but not save the setting.
would preserve
This
On the other
you like the new settings more than the original macro settings. You
could save the new settings as a macro, replacing the original settings.
If you change only the current settings, the new settings remain in
effect until you change them again, or until you turn the printer off.
When you turn the printer off, the original macro remains stored in
memory, but any changes are lost. If you want to save the new settings,
you must save them as a macro.
SelecType
Current setting
a macro, the new macro settings become the
job,
but you don't want to permanently
For example, you may have one macro set for
the original macro.
hand, you might change the current settings, then find
Draft
Draft
10CPI
Off
11.0"
Off
0
136
Italic
USA
Bi-D
Off
Off
*1
stored
in memory). You
as a macro.
2-9