Printing User-Defined Characters - Epson LQ-2500 User Manual

The information about the actual character design (which is contained
in the data statements at the end of the program) is sent to the printer
in the loop between lines 50 and 70.
Note
When defining Letter Quality or proportional characters, put a WIDTH
statement in your program to prevent carriage return and line feed
codes from interfering with your definitions.

Printing User-defined Characters

If you completed the example program above, you defined an arrow
and placed it in the RAM location for ASCII code 64 (replacing the "at"
sign). You can now print out a three-line sample of your work. The first
and third lines (printed by lines 80 and 120 of the program) print the
normal 'at" sign: the second line (line 100) prints the arrow that you
defined. Run the program to see the printout below:
As you can see, both sets of characters (the original ROM characters
that the printer normally uses and the userdefined character set)
remain in the printer available for your use. The command to switch
between the two sets is used in lines 90 and 110. It is:
If is equal to 0, the normal ROM character set is selected (this
R
default). If is equal to 1, the user-defined character set is selected. If
R
you select the user-defined character set before you have defined any
characters, the command is ignored and the ROM characters are still
used.
You may switch between character sets at any time-even in the
middle of a line. To try it, place semicolons at the end of lines 80 and
100 in the program.
Graphics and User-defined Characters
ls@@@ro
@@@@@
ESCape '%" n
the
is
6-17