Superscripts And Subscripts; Mixing Print Styles - Epson LQ-2500 User Manual

Superscripts and subscripts

You can also create superscript and subscript user-defined characters.
Just as Letter Quality characters are defined when the Letter Quality
mode is selected, super/subscript characters are created when either
superscript or subscript is selected.
These super/subscript characters can be used either as superscripts
or as subscripts. The characters are exactly the same; it is only their
placement that differs. The difference between super/subscript
characters and regular characters is that they are smaller They are a
maximum of 16 dots high and their width in dot columns is shown in
Table 6-4.
Table 64. Super/subscript widths
Draft
Letter Quality
Proportlonal
Since super/subscript characters are smaller, they don't require as
much information when you define them. When you define
super/subscript characters, you need only two bytes of data for each
vertical of dots. Design grids for these characters are shown in
row
Figure 6-g on the following page.

Mixing print styles

Each of the three user-defined character modes (draft, Letter Quality
and proportional) can be used in combination with most of the
LQ-2500's various print styles, such as emphasized and double-width,
but not with italic or super/subscript.
Mixing the three types of user-defined characters is not permitted. If,
for example, you select draft and define some characters, then select
proportional and define some more, the first character definitions will
be destroyed. Only one type of character definition may be stored in
RAM at any time.
Graphics User-defined Characters
and
dl
(maximum)
7
23
23
dO + d1 + d2
( m a x i m u m )
12 I
36
42 I
6-19