Problems and Solutions
The printer stops printing
The printer may be out of paper. Check the paper supply.
l
The paper may be jammed. Remove the jammed paper and
l
reload.
The ribbon may be jammed. See the section on replacing the
l
ribbon later in this chapter.
If the
READY
l
printer has stopped to allow the print head to cool. Printing
resumes soon; you do not have to do anything to restart it.
If the printer stops, the beeper sounds, and the
l
does not flicker, turn the printer off and then turn it back on
and try to print again. If
print, take it to a qualified service person.
Single sheets do not feed properly
The position of the paper release lever may be wrong. Push it
l
back to the single-sheet position.
The paper may be too large or too small. See the printer's paper
l
specifications in Chapter 5.
The paper guide may not be installed properly. See
l
on attaching the paper guide in Chapter
The cut sheet feeder mode may be selected by the DIP switch.
l
See the section on setting DIP switches in Chapter 3.
4-4
Troubleshooting and Maintenance
light is off and the
the
light is flickering, the
ON LINE
ON LINE
printer beeps again and does not
2.
light
section
the