Adjusting The Top-Of-Form Position - Epson FX-1180 User Manual

Your printer loads the continuous paper automatically when
you begin printing.

Adjusting the Top-of-Form Position

The top-of-form position is the position on the page where the
printer starts printing. If your printing appears too high or low
on the page, you can use the micro adjust feature to adjust the
top-of-form position. Follow the steps below.
Caution:
c
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Note:
o
Your top-of-form position setting remains in effect until you
change it, even if you turn off the printer.
o
The top margin setting made in some application software
overrides the top-of-form position setting you make with the micro
adjust feature. If necessary, adjust the top-of-form position in
your software.
1. Make sure the printer is turned on.
2. Load paper. (If the tractor is in a push position, press the
Load/Eject button to advance continuous paper to the
current top-of-form position.) If necessary, lift up the
printer cover so you can see the paper position.
3. Hold down the Pause button for about three seconds. The
Pause light starts flashing and the printer enters the micro
adjust mode.
Printing on Continuous Paper
3
3-35