Sony Handycam DCR-HC62 Operating Manual page 69

The power abruptly turns off.
• When approximately 5 minutes have
elapsed while you do not operate your
camcorder, the camcorder ix automatically
turned off/A.SHUT OFF). Change the
setting of [A.SHUT OFF] (p. 52), or turn
on the power again/p. 15), or use the AC
Adaptor.
• The battery is fully discharged, or ahnost
discharged. Charge the batteU pack (p. 12).
The CHG (charge) lamp does not
light while the battery pack is being
charged.
• Slide the POWER sxqtch to OFF (CHG)
(p. 12).
• Attach the battery pack to the camcorder
correctly (p. 12).
• Connect the power cord (mains lead) to the
wall outlet (wall socket) properly.
• The battery charge is completed (p. 12).
The CHG (charge) lamp flashes while
the battery pack is being charged.
• Attach the battery pack to the camcorder
correctly (p. 12). If the problem persists,
disconnect the AC Adaptor from the wall
outlet (wall socket) and contact your Sony
dealer. The battery pack may be worn-out.
The remaining battery time indicator
does not indicate the correct time.
• Amhient temperature is too high or too lo_,
or the battery pack has not been ch ,rged
enough. This is not a malfimction.
• Fully charge the batteW again. If the
problem persists, the battery may be worn-
out. Replace it with a new one (p. 12, 81).
• The indicated time may not be correct in
certain circunlstances. For exanlple, when
you open or close the LCD panel, it takes
about 1minute to display the correct
remaining battery time.
The battery pack discharges too
quickly.
• Ambient temperature is too high or too low,
or the battery pack has not been charged
enough. This is not a malfunction.
• Fully charge the battery agun. If the
problem persists, the battery may be worn-
out. Replace it with a new one (p. 12, 81).
A rippling effect appears on the LCD
screen when you touch it.
• This is not a malfunction. Do not press hard
on the LCD screen.
You cannot turn off the indicator.
• You cannot turn off F_7. Touch F_7 to
check the warning messages (p. 76).
The buttons do not appear on the
touch panel.
• Touch the LCD screen lightly. .-4
• Press DISP/BATT INFO on your
camcorder (or DISPLAY on the Remole =r
Commander) (p. 9 I, 93).
The buttons on the touch panel do
not work correctly or do not work at
all.
• Adjust the touch panel ([CALIBRATION])
(p. 85).
Menu items are grayed out.
• You cannot select grayed items in the
current recording/playback situation.
is not displayed.
• During Easy Handycam operation, not all
menu items arc functionah Cancel Easy
Handycam operation (p. 20).
Continued._
69