Sony Handycam DCR-HC62 Operating Manual page 49

See page 58.
Using tile internal stereo microphone
(p. 90), you can add sound to a tape already
recorded in the 12-bit mode (p. 50) without
erasing the original sound.
0 Notes
• You cannot record additional audkx
When the lape has been recorded in file 16-bit
mode (p. 50).
Whcn file lape has been recorded in the LP
nlode.
Whcll your
c_lnlcorder is conllecl_d via all
i.LINK cable.
When the lape llas been recorded ill 4CH MIC
nlode on ()tiler canlcorders.
On blank sections of the lape.
When the tape has been recorded in a TV
coh)r system other than that of your
camcorder (p. 78).
When tile write-protect tab of the cassetle is
set to SAVE (p. 79).
On sections recorded in HDV ti)rmat.
• When you add sound, the picture will not be
oulpul tioll/the A/V Remote Connector. Check
the picture on the LCD scr_n or the viewfinder.
• You can only record additional audio ovm: a
tape recorded OH your canlcorder. Tile Sollnd
may deteriorate whcn you dub audio on a tape
rccoMed on othcr camcorders (including other
DCR-HC62 canlcorders).
Recording s ound
htsert a recorded cassette into your
camcorder beforehand.
(_) Slide the POWER switch repeatedly to turn
on the PLAY/EDIT lamp.
@ Touch [_ (Play/Pause) to play back the
tape, then touch it again at the point where
YOUwant to start recoKling the SOtlnd.
@ _Fouch Ig2_g01 --+ IMENU]
(EDIT_LAY) --+ tuff] --+ lAUD DUB
CTRL] --+ F6_] --+ [AUDIO DUB].
HI appears.
AUD _B CTRL--_--
_6omi_ = O OO:OO Oo
(_) Touch [_ (Play).
Your camcorder starts audio recording via
the internal stereo microphone.
appears while recording the new sound
in stereo 2 (ST2) during the playback of the
tape.
(_) Touch [_ (Stop) when you want to stop
recording.
To dub on other scenes, repeat step (_) to
select scenes, then touch [AUDIO DUB].
(_) Touch [_ --+ IX].
"_° Tips
• To set tim end poinl tbr audio dubbing,
bethrchmld, press ZERO SET MEMORY on tim
Renlote Commander at the scene at wllich you
want to stop audio dubbing during playback.
After slep @ to @, lhe rccording stops
automatically al the selectcd scene.
To check the recordedsound
(!) Play hack the tape on which you ha_e
recorded audio (p. 26).
@ TouchIgOgff01 ---+IMENUI---+_
(STANDARD SET) ---+ [UK] ---+ [AUDIO
MIXI--+ tug].
@ Touch _1_ to adjust the balance of
the original sound (ST I) and the new sound
(ST2), then touch [_.
0 Notes
• Tile original sound/STI ) is output a,l file deR,uh
setting.
g
Continued._
49