TABLE OF CONTENTS
Section ..............................................................Page
Safety Features / Opener Features
1 etting Started
G -
Poster Review/Infrared Protection Function ...........
2 rogramming
P -
Limits and Force ...................................................................5
to Powerhead ........................................................................ 6
to HomeLink®, Car2U®, Intellicode® 1 Remotes
or Wireless Keypads ........................................................... 6
Programming New Remotes to
Previously Installed Genie® Intellicode® 1
Garage Door Openers
FCC and IC Certification
Monthly Routine...................................................................8
Belt Tensioning Adjustment ...........................................
Travel Limit Reset ...............................................................
Engage & Disengage Carriage........................................
Changing Force Setting..................................................
Changing Speed Setting ................................................
Warranty............................................................................... 12
REFERENCE-Wiring Diagram ......................................... 1 3
OPENER MUST BE INSTALLED WITH THE INCLUDED
WALL CONSOLE.
Safe-T-Beam® SAFETY REVERSE SYSTEM MUST BE
INSTALLED TO CLOSE DOOR.
9/2011
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
. . . . .
.........................................
................................
........................... 3
........................................................6
....................................................6
....................................................7
....................................................7
. . . .
. . . . .
. . . . .
. . . . .
. . . . .
SAFETY INFORMATION
OVERVIEW OF POTENTIAL HAZARDS
. . . . .
. . . . .
. . . . .
2 . . .
READ THIS SAFETY INFORMATION
. 2
CONVENTIONS USED IN THESE INSTRUCTIONS
. 3
Garage doors are large, heavy objects that mov
of springs under high tension and electric motors. Since moving
objects, springs under tension, and electric mot
injurie
s, your safety and the safety of others depend on you
reading the information in this manual. If you have questions or
do not understand the in
trained door system technician or visit our website.
4
The following Safety Alert symbol and signal words are used
throughout this manual to call attention to and identify different
levels of hazard and special instructions.
This is the safety alert symbol. This symbol alerts you
potential hazards that can kill or hurt you and others.
All safety messages will follow the safety aler
and the
word "DANGER", "WARNING", or "CAUTION"
DANGER indicates an imminently hazardous situation which,
NOT avoide
WARNING indicates a potentially hazardous situation which,
NOT avoided, could result in death or serious injury.
CAUTION indicates a potentially hazardous situation which,
NOT a
voided, may result in injury or property damage.
The word NOTE is used to indicate important steps to be
followed or important considerations.
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
. . . . .
. . . . .
. . . . . .
8
SAVE THESE INSTRUCTIONS
Potential
8
Hazard
8
8
9
9
9
9
9
10
10
©2011 The Genie Company
formation presented, call your nearest
d, will result in death or serious injury.
Effect
Keep people clear of opening
WARNING
while door is moving.
Do NOT allow children to
Could result in
play with Door Opener.
Death or
Do NOT operate a door that
Serious Injury
jams or has a broken spring.
Turn OFF power before
WARNING
removing opener cover.
When replacing cover, make
Could result in
sure wires are NOT pinched or
Death or
near moving parts.
Serious Injury
Opener must be fully grounded.
Do NOT try to remove, install,
repair or adjust springs or
anything to which door springs
WARNING
are fastened, such as, wood
blocks, steel brackets, cables
Could result in
or other like items.
Death or
Installations, repairs and
Serious Injury
adjustments must be done
by a trained door systems
technician using proper
tools and instruction
e with the help
ors can cause
to
t symbol
if
if
if
Prevention
2