Parameter Table - Brother HE-800A Instruction Manual

５-５. Parameter table
▪ The parameter values can be stored independently for each program.
▪ The allowable setting range for some parameters may vary from the range specified, depending on the settings of
other parameters. (Refer to "5-5-4. Main restrictions when setting parameters".)
• Depending on the needle zigzag amount and feed amount settings, it may not be possible to carry out sewing at some
setting speeds.
▪ The zigzag width ratio cannot be set when the rear tack pattern is set to an eyelet pattern.
▪ If all underlays have been set, the order of sewing is underlays sewn together, then saw-shape underlays and then
rectangle underlays.
• Parameters that are not applicable to a particular program will be skipped and not displayed.
No.
00 Sewing speed (zigzag part)
01 Buttonhole stitch/Straight tack stitch
0: 1:
02 Length of knife
04 Zigzag pitch
05 Zigzag width
06 Knife X space
07 Knife Y space
Setting items
2: 3: 4:
Setting range
1,000 - 4,000rpm
0: Buttonhole (free)
1: Buttonhole (rectangle)
2: Buttonhole (radial)
3: Buttonhole (round)
4: Bar tack
4.0 - 32.0mm
However, when panel DIP
switch B – No. 3, No. 4 and
No. 5 are at OFF, OFF and
ON respectively
initialization is carried out, the
initial value will be set to 6.0.
0.10 - 2.00mm
1.0 - 3.0mm
-0.4 - 1.0mm
0.00 - 2.00mm
HE-800A
5. OPERATION
Unit
100
1
0.1
when
0.025
0.1
0.1
0.05
Default
3,600
1
13.0
（6.0）
0.350
1.5
0.4
1.00
36