Parameter Table; When The Programmer Is Connected To The Machine With The Taper Tack Specifications - Brother RH-981A Instruction Manual

Chapter 4 PARAMETER

Parameter Table

Described below is the contents of the parameter that is set on each program.
• The parameter values can be stored independently for each program. Each parameter for the taper
tack and the straight bar tack is also independently stored.
• The allowable setting range for some parameters may vary from the range specified, depending on
the settings of each other parameters.
• Two kinds of specifications for the taper tack and the straight bar tack are available as to the
machine and a part of parameters vary with the specifications of the connected machines.
When the programmer is connected to the machine with the taper tack
specifications
No. Setting items
00 Sewing speed
01 Eyelet pattern
02 Button hole length (Note 1)
03 Taper length
04 Offset
05 Stitch pitch
(Note 1) Setting ranges and defaults of stitch lengths may vary with the machine sub-class.
E-18
Setting range
∼
1,000 2,200rpm
∼
1 6
-00:5∼50mm
∼
-01:5 38mm
∼
-02(L1):14 18mm
∼
(L2):18 22mm
∼
(L3):22 26mm
∼
(L4):26 30mm
∼
(L5):28 32mm
∼
(L6):32 36mm
∼
(L7):36 40mm
∼
0 20mm
∼
0.5 2.0mm
∼
0.5 2.0mm
PD-9810
Unit Default
100 1,800
1 2
1 -00:25mm
-01:25mm
-02(L1):16mm
(L2):20mm
(L3):24mm
(L4):28mm
(L5):30mm
(L6):34mm
(L7):38mm
1 6
0.1 1.5
0.1 1.0