Parameter Table - Brother HE-800A User Manual

- . Parameter table

The parameter values can be stored independently for each program.
The allowable setting range for some parameters may vary from the range specified, depending on the settings of
other parameters. (Refer to "5-5-4. Main restrictions when setting parameters".)
• Depending on the needle zigzag amount and feed amount settings, it may not be possible to carry out sewing at
some setting speeds.
The zigzag width ratio cannot be set when the rear tack pattern is set to an eyelet pattern.
If all underlays have been set, the order of sewing is underlays sewn together, then saw-shape underlays and then
rectangle underlays.
• Parameters that are not applicable to a particular program will be skipped and not displayed.
No.
00 Sewing speed (zigzag part)
01 Buttonhole stitch/Straight tack stitch
0: 1:
02 Length of knife
04 Zigzag pitch
05 Zigzag width
06 Knife X space
07 Knife Y space
Setting items
2: 3: 4:
Setting range
1,000 - 4,000 sti/min
0: Buttonhole (free)
1: Buttonhole (rectangle)
2: Buttonhole (radial)
3: Buttonhole (round)
4: Bar tack
4.0 - 32.0mm
However, when panel DIP
switch B – No. 3, No. 4 and
No. 5 are at OFF, OFF and
ON respectively
initialization is carried out, the
initial value will be set to 6.0.
0.10 - 2.00mm
1.0 - 3.0mm
-0.4 - 1.0mm
0.00 - 2.00mm
HE-800A
5. OPERATION
Unit Default
<Other than Chinese
100
<Chinese specifications>
1
0.1
when
0.025
0.1
0.1
0.05
specifications>
3,600
3,200
1
13.0
6.0
0.350
1.5
0.4
1.00
36