Available Sewing Area - Brother HE-800A Instruction Manual

5. OPERATION
No. Setting items
67 Sewing end tension apply timing
68 Rear tack width (rectangle only)
OFF: Condense stitch
69 Program copy
５-５-１. Available sewing area
Work clamp size
(A X B)
5.4 X 19.0
5.4 X 24.5
5.4 X 36.0
6.8 X 24.5
6.8 X 36.0
6.8 X 47.0
7.3 X 24.5
7.3 X 36.0
7.3 X 47.0
∗ ON, ON, ON or OFF, ON, OFF or OFF, OFF, OFF
45
0.1 - 1.5mm
No.3 No.4 No.5 No.7
OFF OFF ON N/A
OFF
∗
OFF
∗
OFF ON ON N/A
ON OFF OFF N/A
ON
∗
ON OFF ON N/A
ON ON OFF N/A
ON
∗
Setting range
-5 - 0 stitches
OFF: Condense stitch
0.1 - 1.5mm
(Normally set to 1.0)
OFF,
1 – 90 (Specify copy source)
The available sewing area (C x D) is determined by a
combination of the work clamp size (A x B) and the
needle plate hole size. Set panel DIP switch B correctly
in accordance with the work clamp and needle plate
being used. (Refer to "13-1. Panel DIP switches".)
If DIP switch B is not set correctly, it will not be possible
to set the normal values for the parameter. In addition,
the needle and cutter may touch the work clamp and
needle breakages or damage to the cutter may result.
3921Q
DIP switch B setting
No.6＝ON
（Needle plate hole size
No.8
5.4mm）
Available sewing area (C x D)
N/A 4.0 X 15.0
ON 4.0 X 20.0
OFF 4.0 X 32.0
N/A 4.0 X 20.0
N/A 4.0 X 32.0
OFF 4.0 X 40.0
N/A 4.0 X 20.0
N/A 4.0 X 32.0
ON 4.0 X 40.0
HE-800A
Unit Default
1
0.1 OFF
1 OFF
No.6＝OFF
（Needle plate hole size
7.3mm）
4.0 X 15.0
4.0 X 20.0
4.0 X 32.0
5.4 X 20.0
5.4 X 32.0
5.4 x 40.0
6.0 X 20.0
6.0 X 32.0
6.0 X 40.0
0