Paper Handling - Epson 400 User Manual

The New Hardware Found screen appears even though the
printer software has already been installed.
Cause
The error may occur in
Windows 95 system.

Paper handling

Paper does not feed properly from the sheet feeder.
Cause
Too many sheets are loaded
in the sheet feeder.
The edge guides are not set
correctly.
Paper is jammed in the paper
path.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased.
The paper's size is not
compatible with the printer.
What to do
Click Do not install a driver
[Windows will not prompt you
again], then click OK.
What to do
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Load paper only up to the arrow
mark on the left edge guide.
Adjust the guides against the stack of
paper. See "Loading Paper" in
Chapter 2.
Turn off the printer and gently pull all
of the paper out of the printer. If it
tears and pieces remain inside the
printer, open the printer cover; then
remove any remaining pieces of paper.
Use only new, smooth sheets of paper.
Use paper that meets the paper
requirements for this printer. See
"Paper" in Appendix B.
Troubleshooting
6
6-13