Epson Stylus Pro 4000 Start Here Manual

EPSON
Start Here
Start Here
Unpack
1
Make sure you have all the parts shown below for your EPSON Stylus Pro 4000:
Roll paper spindle
Warning:
2
Remove all the packing materials and
tape. Save the box and packaging in case
you need to ship the printer.
3
Loosen the two screws and remove the
carriage retainer bracket.
4
Unlock the print head carriage by
pulling the green tab to the left. Do
not remove the tab.
To lock the print head carriage
Note:
for transportation, push the green tab to
the right.
Set Up and Plug In
1
Connect the power cord to the AC
inlet on the back of the printer.
2
Plug the other end of the power
cord into a properly grounded
electrical outlet.
3
Attach the exhaust port cover by sliding it
along the slots on the back of the printer.
4
Insert the paper tray into the slots at
the front of the printer.
Stylus
Printer
Ink cartridges
The printer weighs about 85 pounds, and should be lifted by two people.
Pro 4000
®
Exhaust port cover
Paper tray
Power cord
Spindle adapters
(attached to spindle)
AC inlet