System; General; Time; Account - Digimerge Touch DH200 Series Instruction Manual

SYSTEM

Configure System settings.
Figure 19.0 Setup menu

GENERAL

To configure general system settings:
1. Select the GENERAL tab and configure the
following:
AUTO LOCK
• : Select
touch-screen will be disabled after 3 minutes of
inactivity. Enter your system password (by default,
000000) to disable.
Auto Lock is not available if
NOTE:
Password is set to "OFF."
KEY TONE
• : Select
system will "beep" whenever a button is pressed on
the front panel or remote control
RECORD MODE
• : Displays the current resolution
on the system. To edit, you must use DVR NetView
remote client software (included). For details, see
"SYSTEM" on page 65.
PB INTERLACE
• : Select
flickering will be reduced, but overall image quality
may also be reduced. If OFF, there will be better
image quality on still images, but image flickering
during live viewing and playback.
RUN ON BOOT
• : This option sets the default
recording mode when the system starts up. Select
CONTIN. REC
for Continuous recording; select
SCHEDULE REC
for the system to record
according to a recording schedule(s). For more
details on setting recording schedules, see see
"SCHEDULE" on page 25.
ON/OFF
. If ON, the front panel
ON/OFF
. If ON (default), the
ON/OFF
. If ON, image
PASSWORD
• : Select
prompt you for a password when opening the main
menu
You must set the Password to
NOTE:
"ON" in order to use the Auto Lock.
FACTORY DEFAULT
•
ENTER
button to restore the system to the original
factory settings
KEY SENSITIVITY
•
buttons on the front panel from
2. Press to save your settings. Press
ENTER
to close remaining windows.
CANCEL/ESC

TIME

For more details, on setting the date and time,
see "Recording" on page 16.

ACCOUNT

Only the ADMIN can configure user authorities
on the system.
Figure 19.1 Account menu
To configure user and account settings:
1. Select the ACCOUNT tab, and configure
the following:
USER ADMIN
• : Select
ACTIVATE ON/OFF
• : Select
for the specific user type
AUTHORIZATION
• : Select
BACKUP NETWORK
,
CONFIGURATION
, or
PASSWORD
• : Enter a
user
2. Press the button to save your
ENTER
settings.
Using the Main Menu
ON/OFF
. If ON, the system will
START
: Select and press the
: Adjust the sensitivity of the
1 (low) ~ 5 (high)
USER1~5.
or
to enable the settings
MONITORING
,
PLAYBACK
, ,
SHUTDOWN
6-digit password
for the
29