Using The System; Quick Setup; Using Quick Setup - Digimerge Touch DH200 Series Instruction Manual

USING THE SYSTEM

To power the system ON/OFF:
1. Connect the power cable to the port on the rear panel.
2. Press the
POWER
You need to press the Power button for initial startup
NOTE:
viewing screen on subsequent resets.
You will need to input your system password (by default,
NOTE:

Quick Setup

By default, the system has Quick Setup enabled. Quick Setup lets you quickly adjust the time and
record mode on the system. The system menu will appear as the Quick Setup menu with only Time
and Record options available.
Figure 2.0 Quick Setup menu

Using Quick Setup

Use Quick Setup to set the time and configure basic recording settings.
To set the time:
1. Under the Time tab, select
2. Select and enter the time (hh/mm/ss).
TIME
If using the mouse, you will enter the date and time with the Virtual Keyboard.
NOTE:
3. Press the
ENTER
To configure recording settings:
1. Stop ALL RECORDING on the system. Enter your system password (by default, 000000).
2. Under the RECORD tab, select RECORD MODE and select one of the following: CIF 4CH,
FIELD 4CH, FRAME 4CH, CIF 8CH, FIELD 8CH, FRAME 8CH, or CIF + FRAME.
If "CIF + FRAME" recording mode is selected, only channel 1 will record in frame—the
NOTE:
remaining channels will record in CIF.
3. Under the RECORD tab, select RECORDING DAYS. Press the +/ - buttons and select 12
HOURS, 1~6 DAYS, 1~20 WEEKS, or NONE.
8
button on the front panel or remote control.
and press the
DATE
button to save your changes.
only . The system will load the live
000000
button. Enter the month, day, and year.
ENTER
) to power off the system.