HP 655 Maintenance And Service Manual page 46

4. Remove the battery (see
5. Remove the memory module/wireless module compartment cover (see
on page
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable is connected to the WLAN module #2 terminal.
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board.
(The WLAN module tilts up.)
3. Remove the WLAN module by pulling the module away from the slot at an angle (3).
NOTE:
the protective sleeves must be installed on the antenna connectors, as shown in the
following illustration.
38 Chapter 4 Removal and replacement procedures
Battery on page
36).
The #1 WLAN antenna cable is connected to the WLAN module #1 terminal. The #2
If the WLAN antennas are not connected to the terminals on the WLAN module,
35).
Memory module