Craftsman 358.799211 Operator's Manual page 7

2. ASSIST HANDLE
w Insert the end of the tube through the assist han-
dle. Figure 2 (inset).
b. Align the v.ssist handle between the safety label
and the throttle trigger housing. Seat tube in the
groove in the assist handle. Figure 2.
Co
d_
Insert the tab on bracket I. into the slot on the as-
sist handle. Figure 2. Then, lay the bracket into
place over the tube.
Insert screw C. down through the hole in the assist
handle bracket and then through the assist han-
dle. Figure 2.
e. Assemble washer E. and wing nut E onto the
screw. Tighten securely.
Assist Handle
Figure 2
Handle
Screw C.
3. 'rRI313_R HEAD
v. Place the dust cup "G._ over the hex nut on the
bottom ofthetube. Figure 3. The hexnut should
fit completely inside the dust cup.
b. Hold thedust cup with awrench tokeepthearbor
shaftfrom turning.
c. Thread the trimmer head onto the arbor shaft
against the dust cup and hand tighten firmly_
NOTE: Unless trimmer head istightened ade-
quately, i tcan:unthread when engineisstarted or
stopped. If this situation occurs,reinstall the
trimmer head and tighten more securely.
H-- i
Nut --'P
Dust
CupG.
Direction
to I_t_1
Use awrenchto k_p the
shaft frommmingwhile
spinning the trimmer
headonto the unit.
Figure 3
4. SHIELD ATTACHMENT
tisequipped_tk a_b!l_ter which cutsexcess_ I
[Iinb: t°: thei_proP_'iIeng th_:: !,: ': I
Hole m tube
[ CAUTION: I The line limlter (on the underside of
the shield) is sharp and can cut you.
a. Match the tab on bracket "H." with the hole in the
tube.
b. Attach the shield to the bracket with the two
screws "B." Tighten evenly and securely.
Figure 4
NOTE: Although a screwdriver slot is pro-
vided in screws "B. ", it is easier to install the
screws with a wrench or socket.
NOTE: It is possible that a small space will be
left between the bracket and the shield when
the screws are fi_y tightened.