Replacing And Adding Server Components - Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.1 Operation Manual

2.
Replace the Server
Replace the server.
Use the Maintenance Wizard of the Management Board Web-UI to perform replacement.
For details on the Maintenance Wizard, refer to the PRIMEQUEST manual.
Also, change the BIOS settings of the replacement server to match the operating environment.
For details on BIOS settings, refer to "8.2 Configuring the Server Environment" in the "Design Guide CE".
Shut down the server after completing BIOS settings.
3.
Reconfigure Hardware Properties after Replacement
After replacing the server, reconfigure Resource Orchestrator with the latest hardware properties.
For details on how to reconfigure hardware properties, refer to

9.3.3 Replacing and Adding Server Components

This section explains how to replace and add server components.
-
Replacing and Adding Network Interfaces (Admin LAN, Public LAN)
The procedure used to replace and add network interfaces is the same as that described in
For details, refer to "9.3.2 Replacing
When adding or removing network interfaces, if the target server is running Red Hat Enterprise Linux 5 or Citrix XenServer, after
completing the steps described in
the following command.
# /usr/local/sbin/macbindconfig create <RETURN>
[Xen]
When using Citrix XenServer, reinstall XenServer referring to the Citrix XenServer manual.
When using Red Hat Enterprise Linux 5 Virtualization (Xen-Based) and not using I/O Virtualization (VIOM), perform the following
procedure.
1.
Execute the following command to temporally disable automatic startup of the xend daemon and then restart the managed
server.
# chkconfig xend off <RETURN>
2.
Once the server has restarted, execute the following commands to update MAC address bindings, re-enable automatic startup
of the xend daemon, and restart the xend daemon itself.
# /usr/local/sbin/macbindconfig create <RETURN>
# chkconfig xend on <RETURN>
# service xend start <RETURN>
[Linux]
When the configuration of server components has been changed, check the configuration file of the OS, and make any necessary
corrections. For details, refer to "Configuration File Check" in "2.2.1.1 Software Preparation and Checks" in the "Setup Guide CE".
[Red Hat Enterprise Linux 6]
When adding or removing network interfaces, if the target server is running Red Hat Enterprise Linux 6, after completing the steps
described in "9.3.2 Replacing
For details, refer to "Configuration File Check" in "2.2.1.1 Software Preparation and Checks" in the "Setup Guide CE".
-
Replacing a GSPB
The procedure used to replace a GSPB is the same as that described in "Replacing a network interface".
Replace NIC with GSPB in the procedure.
-
Replacing an HBA
The procedure used to replace an HBA is the same as that described in
Servers".
"9.3.2 Replacing Servers", log in with administrative privileges on the managed server and execute
Servers", modify the configuration file.
"9.3.1 Reconfiguration of Hardware
"9.3.2 Replacing Servers".
- 60 -
Properties".
"9.3.2 Replacing Servers".