Table of Contents
Advertisement
UNPACKING
This product requires assembly.
[] Carefully lift saw from the carton and place it on a level
work surface.
NOTE: This tool is heaw. To avoid back injury, keep
your knees bent and lift with your legs, not your back,
and get help when needed.
WARNING:
Do not use this product if any parts on
the Loose Parts List are already assembled to your
product when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
[] Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily
operated the tool.
NOTE: Remove the foam block from between the saw's
housing and the motor by first beveling the blade (see
page 23).
[] The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
[] If any parts are damaged or missing, please call
1-800-932-3188
for assistance.
A
A
A
A
A
WARNING:
If any parts are damaged or missing,
do not operate this tool until the missing parts are
replaced. Use of this product with damaged or
missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this tool
or create accessories not recommended
for use
with this tool. Any such alteration or modification
is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
WARNING:
Do not lift the saw without help. Hold
it close to your body. Keep your knees bent and
lift with your legs, not your back. Ignoring these
precautions can result in back injury.
WARNING:
Never stand directly in line with the blade
or allow hands to come closer than 3 in. to the blade.
Do not reach over or across the blade. Failure to heed
this warning can result in serious personal injury.
A
WARNING:
To avoid serious personal injury, always
make sure the table saw is securely mounted to
a workbench
or an approved leg stand. NEVER
operate the saw on the floor.
MOUNTING
HOLES
This tool comes mounted to a leg stand. If you chose to
remove the leg stand, the table saw must be mounted to a
firm supporting surface such as a workbench or leg stand.
Four bolt holes have been provided in the saw's base for
this purpose. Each of the four mounting holes should be
bolted securely using 3/8 in. machine bolts, lock washers,
and hex nuts (not included). Bolts should be of sufficient
length to accommodate
the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all four
bolts securely.
Carefully check the workbench
after mounting to make
sure that no movement can occur during use. If any tip-
ping, sliding, or walking is noted, secure the workbench to
the floor before operating.
TO INSTALL
THE BEVEL HANDLE
ASSEMBLY
See Figure 6.
[] Lift the end cap off the bevel handle assembly using a
flat blade screwdriver.
[]
Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.
NUT
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
BEVEL
HANDLE
SCREW
END
CAP
Fig. 6
15
Hide quick links:
Advertisement
Table of Contents
