Changing Vlans Set For External Ports Of Lan Switch Blades - Fujitsu ServerView Respurce Orchestrator Virtual Edition V3.1.0 User Manual

If the IP address of the target switch is set to the same address as that of another unregistered LAN switch unintentionally, change
back the target LAN switch IP address to its original value according to the instructions given in this section.
If there are more than one LAN switch with inconsistent IP address configurations, delete all registered LAN switches according to
"11.4.2 Deleting LAN Switches
-
SSH connection (SSH version 2) can be selected for the following LAN switch blades.
-
LAN switch blade PY CB Eth Switch/IBP 10Gb 18/8 (1.00 or later version)
-
LAN switch blade PY CB Eth Switch/IBP 1Gb 36/8+2 (4.16 or later version)
-
LAN switch blade PY CB Eth Switch/IBP 1Gb 36/12 (3.12 or later version)
-
LAN switch blade PY CB Eth Switch/IBP 1Gb 18/6 (3.12 or later version)
-
LAN switch blade PY CB DCB SW 10Gb 18/6/6 (2.1.1_fuj or later version)

9.4.2 Changing VLANs Set for External Ports of LAN Switch Blades

VLAN IDs and types (Port/Tagged VLAN) set on the external ports of a managed LAN switch blade can be changed.
Note
-
VLANs cannot be changed on PRIMERGY BX900/BX400 LAN switch blades operating in IBP mode.
-
If the port VLAN ID is unspecified or 1, a tagged VLAN ID cannot be set to 1.
-
When using end host mode for the following LAN switch blades, it is not possible to modify the port VLAN ID, or remove a tag vlan
for the external ports which meet the following conditions.
When performing the operation, inactivate the target external port, or change the VLAN ID for internal ports which have the same
VLAN ID as the target external port.
LAN switch blade
-
PY CB Eth Switch/IBP 1Gb 36/8+2
-
PY CB Eth Switch/IBP 1Gb 36/12
-
PY CB Eth Switch/IBP 1Gb 18/6
Conditions
-
The port is selected as Selected Port
-
The port is activated
-
More than one internal port has the same VLAN.
Changing VLAN IDs
This section explains how to change VLAN IDs set on the external ports of a LAN switch.
-
With Port VLANs
Use the following procedure to change VLAN IDs:
1.
In the ROR console server resource tree, right-click the target LAN switch blade and select [Modify]-[Network Settings] from
the popup menu.
The [VLAN Settings] dialog is displayed.
2.
To use this feature, the following settings must first be defined:
VLAN
Select "Change" and select the VLAN ID that has been changed.
" first, then perform discovery and registration according to
- 77 -
"7.4.2 Registering LAN Switches".