Registering Lan Switch Blades - Fujitsu ServerView Respurce Orchestrator Virtual Edition V3.1.0 User Manual

3.
Click <OK>.
The registered server will be displayed in the server resource tree.
Note
-
When an agent is registered on a VM host, all VM guests running on that VM host are also registered automatically. Whenever a VM
guest is created, modified, deleted, or moved on a registered VM host, the changes are automatically updated in the server resource
tree.
-
The VM guest name displayed in the ROR console is either the VM name defined in its server virtualization software or the host name
defined in the guest OS.
The timing at which the host name of a guest OS is detected and displayed varies according its server virtualization software. For
details, refer to "D.3 Functional Differences between Products" in the "Design Guide VE".
-
It is recommended not to use duplicate names for physical OSs, VM hosts, and VM guests. If duplicated names are used, those resources
cannot be managed from the command-line.
-
When registering a server on which the agent was installed, it is necessary to either reboot the server or restart its related services
(explained in the "2.2 Starting and Stopping the Agent" in the "Operation Guide VE") after server registration. This step has to be
done before running any image operation (system image backup or cloning image collection).
For details on how to restart the agent, refer to "2.2 Starting and Stopping the Agent" in the "Operation Guide VE".

7.3.3 Registering LAN Switch Blades

To register a LAN switch blade, its enclosing chassis must be registered first.
Use the following procedure to register a LAN switch blade.
1.
In the ROR console server resource tree, right-click an unregistered LAN switch blade from the target chassis, and select [Register]-
[LAN Switch] from the popup menu.
The [Register LAN Switch] dialog is displayed.
2.
To use this feature, the following settings must first be defined:
LAN switch name
Enter the name to assign to this LAN switch blade.
Enter up to 15 characters, including alphanumeric characters (upper or lower case), underscores ("_"), and hyphens ("-").
Admin LAN (IP address)
Enter the admin LAN IP address that was set on this LAN switch blade.
Enter the IP address using periods ".".
User ID
Enter the name of a telnet or SSH user account that can log in to this LAN switch blade.
For a LAN switch blade PY CB DCB SW 10Gb 18/6/6, enter the name of the administrator account for the LAN switch blade.
Password
Enter the password of the above telnet or SSH user account.
Connection method
Select either [Telnet] or [SSH]. The default setting is as follows:
-
LAN switch blade PY CB DCB SW 10Gb 18/6/6
[SSH]
-
In other cases
[Telnet]
- 32 -