Alarm Feature "Ii" Programming; Alarm Feature "Iii" Programming - Autopage C3-RS-603 Installation Manual

II
FEATURE " " PROGRAMMING:
1 Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in the 'OFF' position.
2 Push the Programming switch 2 times and hold it until the LED turns on and (*) two chirps with a long chirp is heard;
then release the Programming switch. You are now in the feature 'II' programming mode.
3 Press and release the desired transmitter button icon corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Press One Chirp /
Transmitter LED one pulse
Button Factory Default
Setting
Gasoline Engine
1.
20 minutes run time
2.
H2/2 White wire =
+
3.
Constant Parking
Light Output
Door Lock before
+
4.
start
5. 0.8-second Door lock
& Unlock.
Five chirps= 0.8 second lock, dbl 0.8 second unlock
Six chirps= dbl 0.8 second lock, 0.8 second unlock
Exit
: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
III"
FEATURE " PROGRAMMING:
1. Turn the Ignition switch 'ON/OFF' 3 TIMES and stay in the 'OFF' position.
2. Push the Programming switch 3 times and hold it until the LED turns on and (*) three chirps with a long chirp is
heard; then release the Programming switch. You are now in the feature 'III' programming mode.
4. Press and release the desired transmitter button icon corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Press One Chirp /
Transmitter LED one pulse
Button
Factory Default
Setting
Tachometer checking
1.
type.
RPM learning
2.
Start Timer:
0.6-second
Low check level
3.
Second Accessory
+
4.
H3/9 Blue/Black
+ 50 RPM
5. +
DBI ONLY
- 50 RPM
6. +
DBI ONLY
RS-603 REV A.
Two Chirps / Three Chirps /
LED two pulse LED three pulse
Diesel Engine and 10 Diesel Engine and 15
seconds warn-up seconds warn-up
timer timer
10 minutes run time 30 minutes run time
H2/2 White wire =
Flash Parking Light
Output
Door Lock after start Door Lock before &
after start * This is
the preferred setting
when using the
optional XT-11 single
button remote
3.5-second Door 0.8 second lock, 0.35
Lock & Unlock. second unlock
Two Chirps /
LED two pulse
Voltage checking type
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4 chirps),
1.4-second (5 chirps), 1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps), 4.0-second (10 chirps),
Hi check level
Second Start
H3/9 Blue/Black
No RPM learning
No RPM Learning or < 50RPM
12
Four Chirps /
LED four pulse
Diesel Engine and 20
seconds warn-up
timer
5 minutes run time
Without this
feature
0.8 second dbl
lock,0.8 second dbl
unlock
Three Chirps /
LED three pulse
Timer checking type
7/9/2008
Four Chirps /
LED four pulse
DBI TACH **
DATA ONLY !!