Lanview Leds - Enterasys SecureStack A2 A2H254-16 Hardware Installation Manual

Table 4-1 LANVIEW LEDs
LED Color
CPU Off
Red
Amber
Green
State
Power disconnected.
Solid. Boot-up failed.
Blinking. Diagnostics have
failed.
Solid. Diagnostics are running. If the LED remains amber for more than
Blinking. Code image is being
downloaded, or the Manager
switch is copying its
configuration to the other
members in the stack (this
happens automatically every
15 minutes and every time the
"save config" command is
executed.
Solid. System is fully
functional.
Blinking. Boot-up in process.
Recommended Action
If the LED remains off after connecting AC
power or DC power from an RPS, check
the following:
1. Make sure there is power at the power
source (AC source and RPS if
applicable).
2. Replace the power cord with a known
good one or check the continuity of the
power cord.
3. If the SecureStack A2 still does not
power up, the system may have a fatal
error. Contact Enterasys Networks for
technical support.
If the LED remains red for several
minutes, the system may have a fatal
error. Contact Enterasys Networks for
technical support.
Contact Enterasys Networks for technical
support.
several minutes, contact
Enterasys Networks for technical support.
None.
None.
None.
SecureStack A2 Installation Guide
Using LANVIEW
4-3