Figure 3-16
10/100/1000BASE-TX
1 RJ45 device port
2 Other device port
Connecting Fiber-Optic Cables to LC Ports
Warning: Fiber-optic XFPs use Class 1 lasers. Do not use optical instruments to view the
laser output. The use of optical instruments to view laser output increases eye hazard.
When viewing the output optical port, power must be removed from the network adapter.
Advertencia: Los XFPs de fibra optica usan lasers de clase 1. No se debe usar
instrumentos opticos para ver la potencia laser. El uso de los instrumentos opticos para
ver la potencia laser incrementa el riesgo a los ojos. Cuando vean el puerto de la potencia
optica, la corriente debe ser removida del adaptador de la red.
Warnhinweis: XFPs mit Fiber-Optik Technologie benutzen Laser der Klasse 1. Benutzen
sie keinesfalls optische Hilfsmittel, um die Funktion des Lasers zu überprüfen. Solche
Hilfsmittel erhöhen die Gefahr von Sehschäden. Wenn sie den optischen Port überprüfen
möchten stellen Sie sicher, dass die Komponente von der Spannungsversorgung getrennt
ist.
This section describes how to connect
•
a 10GBASE‐SR multimode fiber‐optic connection from the network or devices to an
LC port connector of a 10GBASE‐SR‐XFP, or
•
a 10GBASE‐LR or ‐ER single‐mode fiber‐optic connection from the network or devices
to an LC port connector of a 1000BASE‐LR‐XFP or 1000BASE‐ER‐XFP, respectively.
Eight-Wire Straight-Through Cable RJ45 Pinouts for
À
3 RJ45-to-RJ45 straight-through cable
Á
Â
SecureStack C2 Installation Guide 3-23
Connecting to the Network