Using LANVIEW
Using LANVIEW
The switch supports the Enterasys Networks built‐in LANVIEW LED visual diagnostic
and status monitoring system. The location of each C2K122‐24 LANVIEW LED is shown
in Figure
switch and network problems.
Figure 4-1
1 CPU LED
2 STACK DOWN LED
3 STACK UP LED
4 RPS LED for redundant power-source status
5 Manager LED
Table
appropriate.
4-2 Troubleshooting
4‐1. The LEDs enable you to quickly observe network status for diagnosing
C2K122-24 LANVIEW LEDs
Å
À
4‐2 describes the LED indications and provides recommended actions as
Note: The terms flashing, blinking, and solid used in
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
Ã
Ä
Â
Á
6 Link/Activity LED for 10/100/1000 Mbps,
port 1 of the 24 RJ45 ports
7 Link/Activity LEDs for 10-Gbps XFP ports,
25 and 26
Æ
Table 4-2
indicate the following: