Ariens 991039-Zoom 2452 HD Owner's/Operator's Manual page 19

5.Spin n ew oil f ilter o nto f ilter h ousing until
itmakes contact. Tighten oil f ilter
another 3/4 turn.
6.Install the filter g uards removed in
step 2 .Tighten the mounting screws to
65Ibf-in ( 7.3 N°m).
7.Repeat steps 1 -6 forthe other
transaxle.
8.Follow t he instructions in
To Add
Hydraulic Fluid: on page 18.
3
1. Drain Plug
2. Oil Filter
3. Filter Guard
4. Mounting Hardware
Figure 8
4. Stop the engine and put the transaxle
bypass levers in the drive position. See
Moving the Unff with the Engine Off on
page 15.
5. Start the engine and slowly move the
steering levers in forward and reverse
five or six times.
6. Stop the engine, check the oil level and
add oil as needed.
7. Repeat steps 2-6 until the transaxles
operate smoothly in forward and reverse
at normal speeds without excessive
noise.
MOWER BLADES
Remove
_IL AUTION: Use sturdy gloves or
padding to protect hands when
working with mower blades.
1. Turn the engine off. Remove the ignition
key. Remove the ignition wire from the
spark plugs.
2. Remove the bolts, cup washer, and
blades from the spindle shafts.
Replace
1. Put the blades, cup washers, and the
bolts back on the spindle shafts.
2. Tighten the bolts to a torque of 115-
125 Ibf-ft (156-169.5 N°m).
3. Replace the ignition wire on the spark
plugs.
Purging the Hydraulic System
WARNING: This adjustment
requires operating the engine.
Use extreme care to avoid
contact with moving parts and hot
surfaces. Be sure rear of unit is
well supported and secure before
starting engine.
1. With the unit up to and facing a wall, jack
up the unit so that both drive wheels are
off the ground.
2. Disengage the parking brake and put the
transaxle bypass levers in the neutral
position. See Moving the Unff with the
Engine Off on page 15.
3. Start the engine and slowly move the
steering levers in forward and reverse
five or six times.
GB - 19