Using The Projector On A Network; Wired Network Projection; Connecting To A Wired Network - Epson BrightLink 436Wi Manual

Using the Projector on a Network

Follow the instructions in these sections to set up your projector for use on a network.
Note: To use the interactive pen with your projected computer image, you need to connect the USB
cable, even if you are projecting through the network.

Wired Network Projection

Wireless Network Projection
Wired Network Projection
You can send images to your projector through a wired network. To do this, you connect the projector to
your network, and then set up your projector and computer for network projection.
After connecting and setting up the projector as described here, install the network software from the
Epson Projector Software CD-ROM on your computer. Use the following software and documentation to
set up, control, and monitor network projection:
• EasyMP Network Projection software sets up your computer for network projection. See the
EasyMP Network Projection Operation Guide for instructions.
• EasyMP Monitor software (Windows only) lets you monitor and control your projector through the
network. You can download the latest software and documentation from the Epson web site. Go to
www.epson.com/support
Note: If your projector is connected via a LAN cable to a network that includes a wireless access point,
you can connect to the projector wirelessly using the EasyMP Network Projection software.

Connecting to a Wired Network

Selecting Wired Network Settings
Parent topic:
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100Base-TX or 10Base-T network
cable. To ensure proper data transmission, use a Category 5 shielded cable or better.
1. Connect one end of the network cable to your network hub, switch, or router.
(U.S.) or www.epson.ca/support
Using the Projector on a Network
(Canada) and select your projector.
45