Start-Up - NETGEAR MVBR1210C Getting Started Manual

Start-up

• Allow approximately one minute for the Turbo Hub to boot/start-up.
When the start-up procedure is finished, the following conditions
should exist:
1. The Power indicator
2. The Internet Port indicator
3. The Wi-Fi indicator
4. The LAN Ports indicator
any local Ethernet ports are connected.
5. One of the Signal Quality indicators will light up to show the
level of signal strength on the Bell network.
a. Excellent coverage indicator
b. Good coverage indicator
c. Poor coverage indicator
None of the signal indicators will be lit if there is no coverage.
If any of these conditions do not occur, refer to the troubleshooting section on
page 9 or refer to your User Guide CD.
5
will show solid green.
will show solid or blinking green.
will show solid or blinking blue.
will show solid or blinking green if
will show solid blue
will show solid blue
will show solid blue