Settings For Multiple Projectors; Preparation Flow; Requirements; Projector Id/Remote Control Id - Epson PowerLite Pro Z8150NL User Manual

Settings for Multiple Projectors

Settings for Multiple Projectors
When projecting to a wide screen from multiple projectors, you can
adjust the difference of brightness and color tone between the edges of
each projected image (Edge Blending), to create a seamless screen.
There are two general methods of projecting from multiple projectors.
U Projecting different images from each projector, and creating a
seamless screen
V Projecting the same image from each projector, using the Scale
function to project a large image

Preparation Flow

The following is an example of using method U. (Method V follows the
same basic flow except you use the scale function to adjust the position of
the projected image s p.183)

1. Requirements

2. Setting the projector ID and the remote control ID
3. Adjusting the position of the projected image
4. Checking the Color Mode
5. Using the edge blending function
6. Adjusting to match colors
Settings are explained here using the remote control, but they can also be
set by the control panel.
Requirements
• Two or more projectors that support Edge Blending
• A dedicated computer with a GPU that has two or more outputs (VGA,
DVI, HDMI, etc.) and supports Edge Blending
• Cables to connect the computer to the projectors

Projector ID/Remote Control ID

When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors.
When operating all of the projectors from the remote control, set the ID
switch on the side of the remote control to Off.
175