Cover Open Sensor Removal - Lexmark E350d - E B/W Laser Printer Service Manual

Cover open sensor removal

1.
Remove Tray 1.
2.
Open the front cover.
3.
Open the right side cover. See steps 1 and 2 of
4.
Remove the controller card cover.
5.
Loosen the one screw (A) from the shield that protects the sensor.
6.
Disconnect the cable from J6 on the controller card.
Note: The cable has a toroid. Be sure to remove the toroid before removing the cable.
7.
Use a small Phillips screwdriver to remove the screw (B) holding the sensor.
8.
Remove the sensor.
Reinstallation note:
•
Be sure to re-route the cable back through its retainer.
•
Be sure to place the toroid back over the cable.
"Right side cover removal" on page
4512-420, -430
4-5.
4-15
Repair information