Lexmark E320 - Printer - B/W Service Manual page 157

Restoring factory defaults
Restoring factory defaults returns the printer settings to the original
factory settings.
Go to the Special function menu
following:
1. Select Reset Defaults mode by double pressing the operator
panel button until the Toner Low light is on.
2. Perform a long button press until all lights are on solid.
The printer is reset to factory defaults.
Enter Hex Trace mode
When the printer is in hex trace mode, it prints a hexadecimal and a
character representation of a print job. The printer does not
recognize any print controls or commands in this mode. A hex trace
printout can be used to help isolate the cause of print problems. This
is done by checking the control codes embedded within a print job.
Go to the special function menu
following:
1. Select enter Hex Trace mode by double pressing the operator
panel button until the Paper Jam light is on.
2. Perform a long button press until all lights are on solid.
The printer is reset to factory defaults.
Hex Trace mode can be exited by turning off the printer, or by
pressing and holding the operator panel button to reset the printer.
(page 3-11) and perform the
(page 3-11) and perform the
Diagnostic aids
4500–E320/E322
3-21