At Command Configuration Process - Digicom COMSPHERE 3910 Installation And Operation Manual

Active (Saved)
(ATZ0, ATZ3)
ON POWER-UP, Active
(Saved) IS LOADED TO
Active (Operating)
3910-A2-GN32-40
Customer1
(ATZ1)
LOAD Active (Operating)
USING ATZ OR AT&F
COMMAND
NOTE
Active (Operating)
CHANGES MADE USING ANY AT
COMMAND IMMEDIATELY AFFECT
MODEM OPERATION
USE AT&W COMMAND TO SAVE
CHANGES TO Active (Saved),
Customer1, OR Customer2
Active (Saved) Customer1
(AT&W0) (AT&W1)
Figure 5-2. AT Command Configuration Process
September 1998
Customer2
Factory
(ATZ2)
S Sync
Leased
Answer
(AT&F2)
S Async
Leased
Answer
(AT&F5)
S TMp
Control
(AT&F7)
S Async Dial
(AT&F0)
NOTE
THE AT&W COMMAND IS
DISABLED IF THE Straps
When Disconnected
CONFIGURATION OPTION
IS SET TO Reload
Customer2
(AT&W2)
DCP Configuration
S Sync Dial
(AT&F1)
S Sync Leased
Originate
(AT&F4)
S Async Leased
Originate
(AT&F6)
S TMp Trib
(AT&F8)
S UNIX Dial
(AT&F3)
5-3